• Skip to main content
  • Skip to primary sidebar
  • Skip to footer

972-424-6479

info@garysqualityplumbing.com

GarysLogoFinal_email
  • Home
  • Services
    • Light Commercial Plumbing Services
    • Residential Plumbing Services
      • Gas Work
      • Electronic Leak & Line Location
      • Water Heater Repair & Installation
      • Drain Cleaning (Sewer & AC)
      • Kitchen / Bath Remodeling
  • Ask the Plumber Blog
  • About Us
    • Testimonials
  • Contact Us
  • Locations Served:
  • Plano
  • Richardson
  • Wylie
  • Murphy
  • Frisco
  • North Dallas
  • Home
  • Services
    • Light Commercial Plumbing Services
    • Residential Plumbing Services
      • Gas Work
      • Water Systems
      • Electronic Leak & Line Location
      • Drain Cleaning (Sewer & AC)
      • Kitchen / Bath Remodeling
  • Ask the Plumber – Handy Tips and FAQ’s
  • About Us
    • Testimonials
    • Locations Served
      • Plano TX
      • Richardson TX
      • Wiley TX
      • Murphy TX
      • Frisco
      • North Dallas
  • Contact Us
Home » Ask the Plumber – Handy Tips and FAQ’s

Ask the Plumber – Handy Tips and FAQ’s

Understanding A/C Condensate Lines

August 9, 2011 by Dorothy Skinner 1 Comment

AC Unit.If you’ve ever held a glass of ice water in your hand in a room temperature area you will notice that water collects on the outside of the glass. This is condensation.

In an air conditioning unit the same phenomena occurs. Condensated water collects inside an A/C unit. This water needs to drain out of the unit. Underneath where the condensation occurs there is a pan into which the condensate drains. This is the primary pan and will be piped via a pitched PVC pipe into the drainage system of the home. One way this is done is by using a tee fitting on the drain line under the bathroom or a “hole-in-the-head” fitting behind a bath tub drain.

In case that drain line ever backs up or doesn’t drain for some reason there is a secondary drip pan underneath the primary. This is piped separately to the exterior of the home allowing the homeowner to see if there is a wet spot under the eave and know if something needs to be addressed. It is piped out to be visible.

As a homeowner you should occasionally walk around the perimeter of your home so you can locate the pipes and know where they are. The A/C condensate drain pipe will be:

  • Sticking out of the eave a couple of inches directly down so it will drip onto the ground below.
  • Out of the wall (In this case there will be a 90 degree ell pointing down with a short length of pipe so that it drips lower.)

When you do your routine walk-around outside of your home and notice any condensation contact us. We will come out and make sure your primary drain pipe is cleared so that your secondary drain pipe won’t be dripping water into your yard, or worse, through your ceiling.

The older the system is, the more common it is to see these lines backed up. Over time all kinds of muck accumulates and has to be blown out. If you notice wet spots in your ceiling they really need to be checked out before they get worse. Call us today, 972-424-6479.

Filed Under: Troubleshooter

Problems With Sewer Pipe Drainage

July 27, 2011 by Dorothy Skinner 1 Comment

Washing machine drain pipe.Pitch on a sewer pipe is a measure of how far a pipe should fall over a certain distance on a horizontal run. A proper pitch is what allows the contents of the pipe to keep moving. If you’re experiencing problems with waste leaving your home, this might be an issue and you should call us. Proper pitch on a sewer pipe is between 1/8th of an inch and ½ inch per foot. For example a four foot long pipe should be ½ inch higher on the front than the end of the pipe.

Many plumbing problems can occur if your pipes weren’t installed with the proper pitch. Water will just sit idle in a pipe that’s completely level. Furthermore, if the water is not moving enough or moving in the proper direction, back-ups will occur far more frequently. This isn’t even the worst of it .

Older homes where drainage and sewer pipes are cast iron may have the worst case scenario. Cast iron rusts when sitting under water. Over time a cast iron pipe full of water will simply rot out through the bottom causing a major sewer leak.

If you have frequent back-ups call us immediately. We’ll have one of our dependable plumbers come out to see that your pipes have the proper pitch for your home.

Filed Under: Troubleshooter

Ask Us About Slab Leaks

July 12, 2011 by Dorothy Skinner 2 Comments

You hear water running in your home but just can’t find it. You know it’s not in your head. Perhaps you have had an unusually high water bill or maybe your entire house is full of water. NE Dallas, it’s time to call your plumber!

The process of locating a slab leak is a complicated one, requiring expensive and highly specialized equipment. The knowledge and skills required to use this type of gear doesn’t come in a bag along with rented equipment.

There’s generally a three-step process for slab leak location. Assuming there is a leak that has been isolated to the inside of the home and no evidence of a leak can be found above ground, it is time to locate the leak underground. 

  1. Locate the pipe. We electronically locate the pipe and mark the ground with masking tape so we know exactly where the pipe is located underground and roughly how deep it is.
  2. Listen along the length of the pipe with geophones. We use a geodesic headset which is a very powerful stethoscope with a separate microphone for each ear so that we can listen directionally.
  3. Measure the temperature of the floor along the length of the pipe to find the hot spot.
    This applies only to hot water slab leaks.

These steps come as second nature to any of our plumbers. Those without the skills and training to use this type of equipment, along with a full understanding of the processes involved, should not be allowed to start breaking into the slab. Our plumbers undergo continuing education, it’s an advantage you have with us over a handyman or less-qualified company. We’ll take care to detect and repair your leak while we respect your property.

Give us a call immediately at (972) 424-6479 to have one of our licensed, qualified plumbers come out to determine your next course of action.

Filed Under: Troubleshooter Tagged With: plumbing leaks

Water Heaters in Attics

July 8, 2011 by Dorothy Skinner Leave a Comment

Water heaters.Where is your water heater located? Water heaters can be found in many different areas of a home. Sometimes they are located in a closet, sometimes in a garage. Either of these locations makes sense. However, at some point installing water heaters in attics seemed like a good idea for some. This turned out to be a less than perfect situation. The severity of damage due to leaks greatly increased. Maintenance in replacements became more difficult, especially when put in 2nd floor pull-down attics. Believe it or not it, comes down to closet space. In my opinion, the added ten square feet to the home isn’t worth that much risk.  [Read more…] about Water Heaters in Attics

Filed Under: Plumbing Repair Tagged With: attic water heater, check my water heater

Here’s the Deal with Dottie’s Deals

July 8, 2011 by Dorothy Skinner Leave a Comment

Dottie's deals plano plumber.Introducing ‘Dottie’s Deals’, where you’ll find our most current plumbing specials. We value each and every one of our customers and want you all to know how much we appreciate you.

Gary’s Quality Plumbing wants to help our customers take care of their homes and properties. We hope these specials will help while a very hot and expensive summer is upon us. Check out the newest tab on our web-site called ‘Dottie’s Deals‘ to find our current promotions. Don’t forget to mention them when you call, and don’t wait till they expire! Check back often, but call today, 972-424-6479.

Filed Under: Plumbing Repair Tagged With: promotions

Detecting a Gas Leak

June 22, 2011 by Dorothy Skinner 1 Comment

So, you think might have a gas leak? Locating and repairing a gas leak can be a time consuming and complicated process. Gas companies will tell you to hire a licensed plumber to detect, repair, and permit the finished gas line work.

Gas pipes can be made out of a variety of materials. The gas pipe from the meter to the yard is made out of a specially coated iron riser. This is an L-shaped ridged piece of pipe that the meter hooks on to. Sitting between that riser and another riser at the house is a poly plastic pipe.

Inside of the home the pipe will generally be iron or some type of corrugated stainless steel tubing (CSST). Iron pipe is usually piped up and over the home in the attic with one large main trunk that runs the length of the house. Tees come off of the main line to feed different appliances in the home. If you are dealing with CSST, it will go up from the main line to one central manifold where it feeds an individual line to each appliance in a radial type formation (picture bicycle spokes).

Any of the sections mentioned above are places where a leak could occur. At the meter there are several fittings, including the meter and valve, as well as the top six inches of the riser. Many times subterranean pipes aren’t protected. They should be double wrapped where the riser comes through the ground. A gas leak typically occurs where the connection isn’t wrapped with the special black tape six inches in both directions.

Many types of gas leaks occur outside of the home:

  • At the riser on the house end of the pipe
  • Connections at the manifold and shut-off valves that have not been properly installed
  • Improper installation of flex lines, and gas lines in older homes, that have had pipes run with copper tubing
  • Natural gas eats right through copper, especially at connections where the copper has been flared

Homeowners beware when having your roof repaired! A gas line can leak when it has been improperly installed right next to the roof decking. Most of the time roofers don’t look to see what’s under the roof before nailing new roofing down. It’s common for gas pipes, especially CSST, to be punctured by roofing nails.

HJDGC2AUD969

Filed Under: Plumbing Leak Tagged With: gas leaks, licensed plumber, natural gas

  • « Go to Previous Page
  • Page 1
  • Interim pages omitted …
  • Page 17
  • Page 18
  • Page 19
  • Page 20
  • Page 21
  • Interim pages omitted …
  • Page 28
  • Go to Next Page »

Primary Sidebar

Footer

RMP J. Adam Proctor M-38474

Copyright © 2026 · Genesis Sample on Genesis Framework · WordPress · Log in